Content Comparison

Map Discovery & Credentials

Set the Discovery Settings and Credentials; this converts the agent into a Probe automatically once applied. These options must first be first configured at the Company-level Agents side barsidebar.

Image Removed

Image Added

Reset Agent Configuration

Select to reset the Agent configuration back to the different settings like Reset AD Data, Update Agent, and Reset Agent.

Scan

Select to run a Compliance Scan on demand.

Uninstall

Select to Delete an agent from the portal; you will need to confirm by clicking the Delete button in the confirmation box.

Deprecate

Select to send the Agent to the Deprecated Agents section; you must enter a Reason and tap Yes to complete.

Activate AD Audit

NOTE: AD Audit is only available and supported on agents installed directly on the Domain Controller(s).

Select to start the AD Audit scan; tap Yes to start.

After activating the AD Audit, scans will run automatically every 20 minutes. If any latest changes are made under Computers, OU, or Users, the data will reflect those changes here.

Deactivate AD Audit

Select to stop the AD Audit scan; you must tap Yes to stop.

Start Debug

Select to start the debugging process; , which is used for advanced troubleshooting by our support team generally.

End Debug

Select to end the debugging process.

Fetch Logs

Select to fetch the agent logs; this can take about 5 minutes to complete; use the Download Logs to see them:

Restart Agent

Select to restart the agent; this will restart the CyberCNSAgent service.

Download Logs

You first need to Fetch logs, then use the Download Logs to get them: